TUNA FOOD PROCESSING MACHINERY PARTS, VIZ: Gaskets;
Sub Plates; Spindles; Spur Gears; Gear Housing Covers; Hub
Caps; Shaft Bearing Housings; Base Window Reinforcing
Bars; Window Gaskets; Base Windows; Gear Cases; Cones;
Cups; Liners; Rollers; Pipe Plugs; Drain Cocks; Bushings;
Hex Head Plugs; Dowel Pins; Metering Cams; Screw Nuts;
Screws; Crank Handles; Screw Support Plates; Washers;
Handle Extensions; Metering Piston Center Guards; Side
Guards; Mounting Brackets; Metering Piston Rods; Metering
Piston Guide Rails; Plastic Rails; Knives; Knife Clamp
Bars; Hand Knobs; Knife Anchor Brackets; Knife Anchors;
O-Ring Seals; Tubing; Lube Fittings; Springs; Drive Sleeve
Housings; Clutches; Clutch Sprockets; Coupling Ends; Drive
Chains; Clutch Covers; Dead Plates; Turret Mounting Hubs;
Air Cylinder Housings; Securing Clips; Piston Cam Rollers;
and/or Rods, N.O.S.
| Effective | 29DEC2017 | Expires | 28JAN2018 | Filing Codes | IRE | Filed | 29DEC2017 |
|---|
| From | Los Angeles, CA, United States |
|---|---|
| Via | Long Beach, CA, United States |
| To | Suva, Fiji |
| Via | Auckland, New Zealand |
| Currency | USD |
|---|
| Control No | Basis | Rate | Ctr Type | Service | Min Qty | Units | Via Carrier | Note | Effective | Expires |
|---|---|---|---|---|---|---|---|---|---|---|
| SEA17-16640THIEL | WM | 207.00 | SS | 1,2,3 | 28JAN2018 |
| Notes | 1: NSbj to Rule 10.13: SBJ to a LSFS of $2.00 per W/M, |
|---|---|
| as freighted. SBJ to a minimum of $2.00 per B/L. | |
| 2: NSbj to Rule 2.8B: SBJ to an ISPS of $2.00 per B/L. | |
| 3: NSbj to BLS, CUC, DTHC, OTMC, TMF. |
Applicable Charges